Description

Search no more! The solution to your worn out, dull, damaged, or missing GMC park lights is here! These Classic+ maintain a classic look while providing a brighter, safer, and more stylish park light and turn signal. They connect directly to your stock harness and bulb socket. They require a ground wire to be added by threading a ground wire through the hole in the back of the bulb socket and splicing it into the black wire coming from bulb. The other end of the wire must be securely mounted to the hood's metal surface. They are made from extremely strong ABS plastic. They come with mounting screws for the lenses. LED lights are pre-mounted inside the housings (no need to chase down or restore the stock housings). They work with clear or orange lenses. Lenses are not included in the purchase. They mount directly in the stock 62-66 GMC coves without modification or clips. Just push them in past the tapered ridge. Once you screw the lens into place, no one will be able to remove them without removing the lens. They do not use or need the stock gaskets. Installation Tips: With the lens off, push the light housing into the cove in your hood. You can also pinch the top and bottom of the housing if you’re concerned about your paint. Once the housing is pushed all the way into the cove, it will seat automatically. Don’t worry if there is a little play; the lens will secure the housing once installed. Next, place the lens over the housing and insert the top and bottom screws. Tighten them using a screwdriver (not a drill or similar tool). DO NOT OVER TIGHTEN!!! Keep in mind that the housings are made of plastics and could possibly strip. Once the screw feels snug, you are done. Finally, insert and tighten the screw on each side. As you tighten, press the lens toward the hood to avoid putting stress on the screw’s threads. Again, be careful not to over tighten. These screws just need to be snug. Congratulations! You have installed the new lights! Wiring Tips: Connect your ground wire by routing it through the hole on your bulb socket and then splicing it to your new bulb’s black wire with the connector provided. Then, insert the new bulb’s base into your stock bulb socket. Secure the bulb by winding the excess wire into the light housing and then securing your bulb socket to the back of the housing using the supplied plate and screws. Connect the other end of your ground wire to a clean grounding location on your hood. Legal Disclaimers and Terms of Use: Shindell & Sons Motorworks LLC products are intended for off road or competition use only. Shindell & Sons Motorworks products are intended and sold for off road use only. Use of these products is at the customer’s own risk. Products sold for off road use are intended for off-road and racing vehicles that may never be used on public roadways. These off road only products may be illegal in many municipalities. By purchasing aftermarket, off road only products, the customer takes full responsibility for any use and/or misuse of the product and agrees that Shindell & Sons Motorworks LLC holds no responsibility for any consequences, legal, or otherwise, of such use and/or misuse.